OpenTrafficMap Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== 3D-Printing the Enclosure ======

[[https://codeberg.org/opentrafficmap/its-g5-receiver/src/branch/main/case]]

We recommend printing the enclosure in ASA, which should make it UV-resistant and waterproof. ASA is UV-resistant without any special additives, so the filament manufacturer shouldn't really matter. We always buy the cheapest one in white.

==== Required materials ====

^ Quantity ^ Item ^
| 3 | M3 heat-set inserts |
| 2 | M4 heat-set inserts |
| 3 | M3 × 4 mm button-head or socket-head cap screws |
| 2 | M4 × 8 mm button-head or socket-head cap screws |

==== Images ====

| {{:hardware:enclosure:bottom_screw_hole_with_thread_behind.jpg?250|}} | {{:hardware:enclosure:bottom_with_heat-inserts_1.jpg?250|}} | {{:hardware:enclosure:carrier_front_with_SMA.jpg?250|}} |
| {{:hardware:enclosure:carrier_with_heat-inserts.jpg?250|}} | {{:hardware:enclosure:PCB_on_carrier_with_SMA.jpg?250|}} | {{:hardware:enclosure:bottom_screw.jpg?250|}} |
| {{:hardware:enclosure:bottom_with_heat-inserts_2.jpg?250|}} | {{:hardware:enclosure:carrier_with_heat_insert_and_bulkhead_hole.jpg?250|}} | {{:hardware:enclosure:inserted_carrier.jpg?250|}} |