Differences

This shows you the differences between two versions of the page.

--- en:hardware:enclosure [2026/08/06 17:54] – Initial English translation of gehaeuse fasteiner
+++ en:hardware:enclosure [2026/09/02 21:41] (current) – flope
@@ Line 5: / Line 5: @@
 We recommend printing the enclosure in ASA, which should make it UV-resistant and waterproof. ASA is UV-resistant without any special additives, so the filament manufacturer shouldn't really matter. We always buy the cheapest one in white.
+==== Required materials ====
+^ Quantity ^ Item ^
+| 3 | M3 heat-set inserts |
+| 2 | M4 heat-set inserts |
+| 3 | M3 × 4 mm button-head or socket-head cap screws |
+| 2 | M4 × 8 mm button-head or socket-head cap screws |
+==== Images ====
+| {{:hardware:enclosure:bottom_screw_hole_with_thread_behind.jpg?250|}} | {{:hardware:enclosure:bottom_with_heat-inserts_1.jpg?250|}} | {{:hardware:enclosure:carrier_front_with_SMA.jpg?250|}} |
+| {{:hardware:enclosure:carrier_with_heat-inserts.jpg?250|}} | {{:hardware:enclosure:PCB_on_carrier_with_SMA.jpg?250|}} | {{:hardware:enclosure:bottom_screw.jpg?250|}} |
+| {{:hardware:enclosure:bottom_with_heat-inserts_2.jpg?250|}} | {{:hardware:enclosure:carrier_with_heat_insert_and_bulkhead_hole.jpg?250|}} | {{:hardware:enclosure:inserted_carrier.jpg?250|}} |